MGE Data, s.r.o.

HW and SW Products

MobiTest GSLI

on-line Tracking Meter

MobiTest GSL is the new generation model, which is equipped with broad range of sensors and barecode scanner. By the help of GSM modul it is possible to activate on-line data transfer and on-line firmware updating. MobiTest GSL was primarily designed for long terming mobility studies in order to outdoor audience measurement system.

Barecode scanning was never easier.To optimize the scanning time it is possible to pre scan a code which automatically switches the unit into a mode optimized for different norms of bar codes. Scanning of code is activated by pressing blue button or by turning the device with back side to top.

There is wide range of customization to achieve the most convenient solution for each individual project. See comon options below.

SENSORS:

Ublox 5 assisted GPS, GALILEO – 50 Sat., Fix 1 sec.
3 Acclerometer sensors
Gyroskope
Kompass
Barecode scanner

(Supported codes: UPC-A/UPC-E, EAN-8/EAN-13, Industrial 2 of 5, Codabar, Matrix 2 of 5, Code 11, Code 93, Code 32, Code 128, Standard Code 39, Full ASCII Code 39, Interleaved 2 of 5, China Postal Code, MSI Plessy Code, UK Plessy Code, EAN/UCC 128, Telepen Code, IATA Code, GS1 Databar.)

Keyboard
GSM/GPRS
Battery control sensor
Sleep status sensor
Thermometer

TECHNICAL DATA:

Internal memory – 1GB = 8 months of data collection
Measures fast positioning 0.1 sec (optimum 1 sec)
Time to first fix in 1–10 seconds in average
On batteries without sleep mode up to 100 hours (depends on configuration and conditions)

VALUES:

GPS: X,Y,Z,SATS,TIME,DATE,HACC,VACC
GSM: BTS Station Location
AWLI: Tag Detection, up to 50meters distance detection, 180 degree
ACC: X,Y,Z 10Hz Acceleration
TEMP: temperature
MIC: sound

INTERFACES:

online (GPRS) transmition in 3–5 sec (during charging or any time)
Encrypted Blue Tooth for Setup and direct access
An alternative is USB 2.0
Beeper and LED for status reports and alerts